WP XPLOR PRO cone valve fork adjustment wrench

WP XPLOR PRO cone valve fork adjustment wrench

WP XPLOR PRO cone valve fork adjustment wrench. Made of 2 mm black anodized aluminum. The adjustment area is made in PA3 12D printing to avoid marking the anodizing of the fork. Specially designed for adjusting the suspension of the Xplor PRO “cone valve” White Power forks of the KTM 790 and 890 Rally with a 35mm nut.

Our opinion 

Curiously, with the money this motorcycle costs, those of KTM They have forgotten to give customers a wrench to adjust the front White power Cone Valve suspension. So after several requests from our customers, we have decided to manufacture this adjustment wrench.

It is specially designed to not mark the adjustment parts. In addition, it is so light and minimalist that you can carry it in your tool bag without it bothering you. The black anodizing gives an extra layer of protection to the aluminum wrench and the tightening zone made of PA12 will prevent the delicate hex adjustment nuts from being scratched. We have also incorporated a hole in it in case you prefer to leave it hanging in your workshop. We strongly recommend reading the instructions for use of the suspension before starting to regulate it. And above all, write down all the original settings just in case you don't manage to improve it, so that at least you can leave it back as it was. In this type of suspensions, 2 clicks can make the difference.

Take a look at the rest of the material we manufacture by clicking HERE.

En Viejos Pistones we are specialists in the preparation of off road motorcycles for raids or trips as well as in the manufacture of accessories. If you have any questions about our products, you can contact us through whatsap on the website or by sending us an email to: [email protected]